🌐 Translate
Automatic translation is available via Google Translate: Open translated version.
FM broadcast receiver
The radio can receive broadcast FM from 76 to 108 MHz. It uses a separate chip (BK1080) for this. RDS is not supported.
During normal broadcast listening, the active VFO still has priority. Reception on the active VFO temporarily disables broadcast audio; at the end of VFO reception, the radio switches back to broadcast. While a manual or automatic FM station scan is actively running, v5.9.0 temporarily ignores main-channel reception so the station scan can finish without being interrupted.
Note
Where this page mentions
UP/DOWN, use the equivalentLEFT/RIGHTkeys on UV-K1. The active navigation layout followsSetNav.
Note
- the active VFO has priority during normal broadcast listening, but not during an active FM station scan
- auto scan overwrites all
48FM memories
Basic operations
F+0 FM, long-pressing0 FM, or a custom button function starts broadcast receptionEXIT, or using the same start command again while the radio is in FM mode, ends broadcast receptionF+3 VFO/MR, or long-pressing3 VFO/MR, changes between VFO mode and memory mode
Set a frequency in FM-VFO mode
Simply typing a frequency tunes the receiver. The resolution is 100 kHz, so entering 929 tunes to 92.9 MHz. Use the arrow keys to change in 100 kHz steps.
Change the FM broadcast range
If you cannot tune the station you expect, you may simply be in the wrong FM broadcast range.
While FM broadcast reception is active, long-press 1 BAND to cycle through the available FM ranges:
87.5to108 MHz76to108 MHz76to90 MHz64to76 MHz
The currently selected range is shown at the bottom-left of the FM screen, for example 87.5-108M.
Direct tuning, manual scan, auto scan, and FM memories only work inside the currently selected range. If a station or saved FM memory is outside that range, switch to another FM band first.
Store in memory from FM-VFO mode
Pressing M in VFO mode allows you to store the current frequency in a memory channel. Use the arrow keys to select the memory, then confirm with M. There are 48 memories available.
Select a memory
In MR mode, entering 01 to 48 selects a memory channel. Use UP / DOWN to step through memory channels.
Delete a stored memory
In MR mode, pressing M allows you to delete that memory channel.
Scanning for stations from FM-VFO
Auto scan
Start with F + * Scan or by long-pressing * Scan.
The radio scans for stations and stores the first 48 stations in memory. Scanning starts at the low side of the band. Starting auto scan deletes previously stored channels. EXIT ends auto scan.
While auto scan is running, an incoming signal detected on the main transceiver channel does not interrupt the FM scan. Normal main-channel priority is restored as soon as FM scanning stops.
Manual scan
A short press on * Scan starts manual scan. The radio scans upward from the current frequency until a station is received. You can continue scanning in either direction using the arrow keys. EXIT stops scan mode.
The same temporary main-channel exception applies during manual scan. Once the scan stops on a station or is cancelled, ordinary broadcast listening again yields to reception on the active VFO.
Button functions
1 BAND- long press, switch FM broadcast ranges3 VFO/MR- switch frequency/memory mode* SCAN- short press - start single scan
- long press - start auto scan (all memory channels will be deleted and replaced with scan result)