- Add CwDsp with FIR bandpass filter, envelope detection, Goertzel tone detector
- Add CwDecoder with real-time Morse timing analysis and character lookup
- Add CW state/actions to RadarState, wire into RadarViewModel
- Add collapsible CW decoder panel to transceivers page
- 19 unit tests covering DSP, Morse table, and decoder state
- Shares IAudioCapture with SSTV, auto-stops SSTV when CW starts
- Add DopplerFrequencyCalculator utility with passband mapping + Doppler correction
- Add MHz input UI with real-time 1Hz refresh during pass
- Add kHz offset for downlink frequency correction
- TX/RX fields on same row for compact layout
- 40 unit tests covering linear/FM/inverted transponders
I was setting the Tx frequency only when we were
in Tx mode, but the Icom 705 will accept the
command to set the Tx frequency even when in Rx mode, so
there is no need to check the PTT state before sending the command.
- Added support for Icom IC-705 radio model with split mode functionality.
- Updated RadioTrackingService to handle single-radio split mode and dual-radio configurations.
- Modified MainContainer to provide appropriate radio controllers based on selected model.
- Enhanced SettingsRepo to include split mode preference in radio control settings.
- Updated UI in SettingsDialog to allow toggling of split mode for IC-705 and adjust device selection accordingly.
- Improved handling of baud rates based on selected radio model.
- Added extended operations in IRadioController for IC-705 specific commands.
atsunatsu